Product code: UCR-CH-010
Suspension K&C Measurement System
Vehicle Dynamics & Chassis
Information and quotation request
Just mention the product code in your request. Sharing specimen details and the test specification speeds things up.
About the system
The suspension K&C (kinematics and compliance) measurement system clamps the vehicle body and applies vertical, longitudinal and lateral loads through wheel pads to measure suspension geometry changes and compliance. Camber, toe, wheel-centre motion and spring/damper characteristics are extracted for vehicle dynamics development and simulation-model validation.
Technical scope
- ≤5 t
- Z 30 kN
- XY 15 kN
- Steer 45°
Test functions and capabilities
- Bump/roll kinematics: camber, toe, track change
- Longitudinal and lateral force compliance
- Aligning moment (Mz) compliance
- Steering kinematics (±45°)
- Data for simulation model validation
Configurations and technical data
| Configuration | Technical values |
|---|---|
| Vehicle | ≤5 t; track 1–2 m; wheelbase 2–4 m |
| Vertical (Z) | 30 kN; 200 mm |
| Longitudinal/lateral (XY) | 15 kN; 150 mm |
| Mz / camber / steer | 1000 Nm / 10° / 45° |
Values show the range of available configurations. Final technical values are defined by the project specification.
Project scope
- Joint definition of the technical specification
- Configuration and layout proposal
- Installation, commissioning and acceptance tests
- Operator training and after-sales technical support